Solution 1: Enable drive in BIOS. If your hard disk is not being detected in BIOS, it is possible that the drive has not been set up yet.
Solution 2: Update drivers. If the device drivers in your system are out-dated, there are chances that the hard drive may not be detected.
Solution 3: Replace data cable.
Solution 4: Check for issues with SSD.
Why is my SSD not showing in BIOS?
Undoubtedly why is my SSD not recognized? Faulty or possibly disconnected data cable
Outdated device drivers
Drive no longer enabled in BIOS
Bad SSD boost not recognized by computer
Why is my SSD not showing Windows 10?
Restart your computer.
Press the F2 key.
Press Enter.
Select Serial ATA.
Press Enter.your
Save the changes you made to the SATA controller mode setting.
Restart your own computer to enter the BIOS.
How to get windows to recognize new SSD?
In order for the BIOS to understand the SSD, you need to configure the SSD settings in the BIOS as follows: Restart your computer and press the F2 key after the amazing screen.
Press Enter to enter settings.
Select Serial ATA and press Enter.
Then look for the “SATA Controller Mode” option.
Save your changes and reboot your hard drive to enter the BIOS.
Why is my SSD drive not showing up?
Right-click “This and PC” and select “Manage”. Look in “Device Manager” under “System Tools”.
Go to Disks. It does list the storage that your entire family’s devices have connected to your PC.
Right click on my SSD and select “Remove device”.
Remove this SSD and reboot the system.
How do I fix SSD not detected in BIOS?
Solution Multiple setup: BIOS SSD options Reboot one computer and press the F2 key when the first screen appears. Press Enter to display Config.Serial, select ATA and press Enter. You will then see the Controller SATA Mode option. Save your changes and restart your computer to enter the BIOS.
How do I fix SSD not detected in BIOS?
Solution 2 – Configure SSD in BIOS settings Restart the Internet and press the F2 key right after the first screen. Press Enter to go to Config.Serial, select ATA and also press Enter. You will then see the “SATA Controller Mode” option. Save your changes and restart your computer to enter the BIOS.
